Specially designed for accurate and repeatable testing of composite materials, the Seatallan range includes compression fixtures, short beam shear test jigs, peel jigs and tensile test jigs.
Our precision grips and fixtures enable you to perform mechanical tests to assess the full characterization of the properties of anisotropic and homogeneous composite materials. All our test fixtures can also be changed quickly and easily so you can perform a wide range of tests and reduce productivity time lost through to test delays.
Our compression testing fixtures are compliant with all relevant ASTM, ISO, prEN and DIN test standards.
Buy your Seatallan Composites jigs and Fixtures online now, or you don't see what you need from our range below, call us on +44 (0)1489 790049. We can engineer any bespoke solutions required to your exact specifications.
ST107 ASTM D 6641 COMPRESSION OF COMPOSITES
ST113 ASTM D 5748-95(20112) PUNCTURE JIG
This fixture complies with the requirements of ASTM D 3410 for testing composite materials in compression. The top and bottom halves of the fixture are guided on precision linear bearings to ensure accurate alignment.
Designed to take a restricted sample size, both in width and thickness compared to the full range fixture ST55, this fixture is both lighter and cheaper.
The German DIN standard test is a modification of the American ASTM D 3410 Celanese test. The Celanese test jig has conical tapered wedges which only contact correctly at one position in the body, thus sample thickness is critical to get full wedge contac
ST57/1 DIN 65 380 CELANESE COMPRESSION FIXTURE
ST57/2 DIN 65 380 CELANESE COMPRESSION FIXTURE WITH GUIDE BEARINGS
A guided three point bend jig in accordance with ASTM D 2344 designed to test the interlaminar shear properties of composite materials.
Typically this jig is used to test aluminium faced honeycomb cored structural panels used in the aerospace and similar industries. The test measures the force required to peel the facing sheet from the core, thus testing the effectiveness of the adhesive
This jig is used to test the peel strength of laminated samples where the backing sheet is rigid and the facing sheet is flexible. It complies with both the DIN and ASTM standards.
A split ring, is fitted to the inside of the annular shaped sample. The two halves of the split ring are separated by the action of the testing machine, applying a tensile load to two sections of the sample.
ST61/1 ASTM D 2290 SPLIT DISC TENSION TEST FOR SAMPLES TYPE A & B
ST61/2 ASTM D 2290 SPLIT DISC TENSION TEST FOR REDUCED SECTION SAMPLES
ST61/3 ASTM D 2290 SPLIT DISC TENSION TEST LARGE DIAMETER PIPE SAMPLES